453-stereo-removal.htm¶

1 excerpts.

453 Stereo Removal¶

evilution.co.uk/mod/453-stereo-removal.htm · p. 1 · Applies to: 453

Mod Details Premium No Difficulty Mod ID 1344 Credit evilution For Link https://evilution.co.uk/mod/453-stereo-removal.htm Copy to Clipboard Smart Audio System This is the basic stereo found in the 453. Take a plastic spudger and jam it in between the black cowel and silver band. Work all the way around from 1 side, underneath and to the other side to disconnect all of the clips. Lift the bottom to disconnect the top hooks. There are a few clips. Pay close attention to the top hooks. You are now left with the stereo uncovered. Remove the 4x Torx20 screws. The stereo can now slide out and the 3 electrical connections can be disconnected. The stereo is an awkward design that seriously limits the aftermarket stereos that we can fit instead. Smart Media System This is the upgrade media system that can be specified on your 453. Use a plastic spudger along the bottom between the silver ring and the rear housing. Pull it from underneath as there’s plastic hooks along the top. Lower the front down… …and disconnect the face plate. There are 4x Torx20 screws, 2 on each side. The driver’s side is a bit tricky because of the access. I found that lowering the steering column all the way down gave just enough access to remove them. Pull the screen clear… …look down the back and disconnect all of the connectors. Cool. Look in the back of the housing, there are 4x Torx20 screws. 2 at the top… …and 2 at the bottom. Use a magnetic screwdriver because it’s easy to drop these. Pull the housing from the dashboard. Use the spudger to unclip the dashboard trim, grab and pull. This reveals the stereo control box. Remove the 4x Torx20 screws… …and then slide the controller out. Disconnect all of the connectors and the controller is free from the car. When refitting the front panel, clip in the top hooks before pushing the bottom of the trim in place. Refitting The Trim You don’t have to remove the speedo if you know about the angle and the wiggle. Smart Media System Connect When smart face-lifted the 453 in 2109, they replaced the touch screen stereo with one from Bosch. It has Apple Carplay. Get a plastic spudger and go in behind the silver bezel. Work along the bottom. There are 2 clips on the right, 2 clips on the left and 2 clips on the bottom. They just pull to unclip. Once all 6 clips have unclipped, hinge the face up to disconnect the hooks at the top. You can see the hooks at the top, they reach in further which is why you have to lift the fascia from the bottom to free them This reveals 3x Torx20 screws. Remove them. Pull the stereo stereo out to reveal the electrical connections. Start with the Fakra connections. Blue – GPS Brown – FM White – DAB On the other side are a full set of 4 ISO connectors. Disconnect them by pressing the tab in on the side of each plug and pull the plug out. Click if info helped 39 likes 26501 views Print